Installation and construction method of sweat steaming room.inground hot tubs for sale

　　1. Choose a suitable installation location. Due to the limitations of the structure and housing environment of the home, it is not possible to find a square and upright room like a commercial one. Generally, household sweat steaming rooms choose idle areas, such as attics, staircases, corners of underground rooms or parts of balconies, as well as renovated bathrooms or cloakrooms. The area should not only consider ventilation and exhaust, but also waterproof isolation. The frequency of use and the division of nearby functional areas should be considered. Generally, household sweat steaming rooms are for use by their own family or relatives and friends, so the location should choose a suitable space for installation.

　　2. Choose a reasonable circuit layout. Generally, the power of a household sweat steaming room is not very high, usually around 2KW. Ordinary sockets cannot ensure electricity safety. Generally, we recommend using dedicated lines or air conditioning lines, with at least 4 square meters of dedicated lines reserved at a height of 1.5 in the room. Of course, grounding is essential.

　　3. If the installation of a household sweat steaming room is purchased as a mobile device, you can assemble it yourself. After unpacking, find the manual, and then splice the base, rear wall panel, left and right wall panels, and stool panels according to the requirements. Connect the heating wires inside the stool panel, install the front panel, cover the top cover, and then connect the plugs in all directions. These are fixed interfaces, some are numbered, find the corresponding connection, some are anti fooling interfaces, and if not, they cannot be plugged in. After all lines and buckles are connected, check again and confirm that there are no errors before plugging in and opening before testing. If the various functions of the operation panel display normally, the assembly is completed and can be used normally. If there is a display fault, find the fault point and troubleshoot it.

　　4. Wall wiring: We can see that there are several wire terminals connected to the left and right sides of the back wall. The wire terminals are connected using wiring clips, and we can find two different ones and directly plug them in. This way, all the wire terminals are plugged in like this. This way, the wall connection is already done. Then put on the stool board. There are two small boards with a height of 35 centimeters inside, which are called the stool board. We stand them up and place them in the pre made slots in the family sweat steaming room. Cover them with the board and the stool surface can be used to place the front face of the sweat steaming room. The one with the door is the front face. Similarly, install the front face to place it on the ceiling;

　　5. Clean up the debris in the room, then remove the electrical wires, air conditioning, water pipes, and other items inside the room, restore the smoothness of the surrounding area, and then pull a separate set of copper core wires from the main electricity meter to the door of the room. It doesn't matter whether the door is made or not, because this contractor will customize it! After completing these tasks, wait for the contractor to send someone to install the household sweat steaming room, and then the sweat steaming room can be inspected and accepted!

Read recommendations:

outdoor infrared sauna barrel

Hot Tub HT-102

thermowood outdoor sauna garden cabin supplier

cold plunge tub with chiller Supply chain

How much does it cost to open a sweat shop?outdoor wooden hot tub