Construction of sweat steaming room.average cost of inground hot tub

　　The construction of sweat steaming rooms is generally divided into four floors. The first floor is close to the floor or wall, and the Ping An Nano Sweating Room releases calcium carbide gas, jade, crystal and other mineral energy dishes laid on the wall or ground in the form of far-infrared, negative ions, sub ions, bioelectricity, and other substances through heating elements. For insulation layer, fire-resistant insulation materials with limited performance, such as rock wool, should be selected; The second layer is a thermal reflection layer, which is laid with a thermal reflection film to reduce thermal backscatter and improve thermal efficiency. Commonly used is a thermal reflection film coated with aluminum; The third layer is the heating layer, which is rare to use electric heating plates, heating cables, and electric heating films in conjunction with temperature controllers. Electric heating plates are the best and safest for quality pots, but they are the most expensive and cannot be cut. Although the heating cable has the lowest price, its quality is the worst, and it also has limitations such as uneven heat distribution, easy aging, and poor heating effect. Electric heating film is the most suitable for use in sweating sauna health rooms, with better cost-effectiveness than the first two. Products with good quality have been used for more than 10 years without any problems; 4th layer functional data surface layer. The floor can be laid on the keel, or after laying pea stone concrete on the heating cable, floor tiles can be laid on the waterproof layer and leveling layer. The wall surface can be paved with mineral particles such as pumice stone, tourmaline, pewter stone, jade, crystal and nano powder on the leveling layer according to the functional needs. The method of topping is similar to that of walls and floors, with heating elements such as non electric heating membranes supported on the top and an additional layer of energy powder such as calcium silicate or negative ions added. The main purpose is to form a temperature zone with the slope, so that the ceiling in the steam room has the same temperature as the ground and walls, achieving good heating effect.

Read recommendations:

traditional wooden hot tub

Cold Hydrotherapy price

ice bath with chiller exporter

Canadian Red Cedar Infrared Sauna with Starry Sky Ceiling (Model IS-1401)

The making of domestic sauna room.thermowood outdoor sauna garden cabin