Installation of home sweat steaming room.Redwood hot tub supplier

　　1. The room door can retain the previous door or be dismantled and installed by oneself. Generally, the original door used to be a wooden door, and stainless steel doors can be left untouched. If it is a glass plastic door, it is recommended to remove it and reinstall it! Because these types of doors are prone to thermal deformation and release odors and toxic gases, it is advisable not to paint the door leaves, especially the side inside the room! If you really don't know how to do it, then you can have the contractor customize it, but the cost of passing the door is definitely necessary!

　　2. There should be no wires inside the room, and wires should be pulled outside the door! Do not use wires inside the room, and a dedicated line is also needed outside the room door. Pull a set of three copper core wires separately from the main electricity meter to the room door, remember it is a copper core wire, and there are also three wires, one fire, one ground! Once the wire reaches the entrance, you can drill a hole near the door and let the wire enter!

　　3. The room can be located at a height of 2.5 meters or above, any position is acceptable. A 10cm circular hole can be drilled outside the room, which is used for installing exhaust fans in the future. Therefore, some households have dedicated exhaust pipes, so it is necessary to connect the air to the exhaust pipe!

　　4. After completing the above work, take a ruler and measure the length, width, and height of the room. Draw a picture and mark the length, width, and height, as well as the position and size of the pillars. If there are windows, mark the length, width, and height!

Read recommendations:

cube outdoor sauna

Cold Plunge CT-14 Pro

Redwood hot tub manufacturer

sauna barrel outdoor

Children's Use of Saunas