A simple guide for installing household sauna equipment.sauna stove wood burning

　　The installation of equipment in a family sauna can be easily completed through the following steps. Before starting the installation, please ensure that the basic work of the room has been completed, including cement sand smoothing the ceiling, walls, and floors, and reserve sufficient power lines at the main meter. In other words, the preparation work for the room should be done well!

　　1. Determine the location of the sauna: Choose a suitable location for placing the sauna, and it is usually recommended to choose a corner far from the wall to ensure air circulation. Of course, the location of the inlet and outlet also needs to be considered,

　　2. Pull three copper core wires: Pull a set of three copper core wires from the main meter through the air switch to the door of the room. Please be sure to hire an electrician for operation to ensure safety and reliability. The three wires are the neutral wire, the live wire, and the ground wire. The size of the wires should be determined based on the size of the area. Generally, pulling 6 square wires within 6 square meters is sufficient, and pulling down 10 square wires below 15 square meters is sufficient. Generally, households use a voltage of 220V, which is common sense. For commercial use, 380V may be used, depending on the situation!

　　3. Install the sauna: Place the sauna in the designated position and ensure that it is securely fixed to the ground. Connect the power cord of the sauna to the pre wired copper core wire to ensure proper wiring. The thing to note is that the prerequisite for doing this step is that the ceiling, walls, and floors have already been laid with wooden boards. Generally, ceiling walls use buckle plates, and floors use wooden flooring, but not all of them. Just give a discussion of something that everyone is familiar with, and I won't go into detail if it's too personalized!

　　4. Exhaust system setting: According to the design requirements of the sauna room, install appropriate exhaust systems inside or outside the room to ensure good ventilation and humidity control. You can install an exhaust fan inside, and it is necessary to draw air after use. If it is not installed, it is not a problem. It is also possible to open the door and blow.

　　5. Install control system: Install the corresponding control system according to the model and specifications of the sauna stove. Connect the control system to the sauna and ensure its normal operation.

　　6. Protective measures: In order to protect the safety of users, appropriate protective equipment such as thermometers, access control, etc. should be installed in the sauna room. Surround the sauna with wooden boards or something, after all, this guy is very hot, and accidentally touching it can cause a layer of skin to fall off. Some will install automatic sprinkler, but it is not recommended. Manually scooping water is good. Automatic sprinkler is good, but it is easy to break down. This practicality is not very good!

Read recommendations:

far infrared sauna room Supply chain

Cold Hydrotherapy Factory

cedar cold plunge company

cedar barrel sauna

Knowledge that needs to be understood before installing and constructing a family sweat steaming room