Customization process for sweat steaming room and wet steaming room

　　Firstly, we need to take a shower, then change into a sweat steam suit, and then go to the sweat steam. In terms of this, the sweat steam and shower room can be separated by a certain distance, without the need to put the sauna room in the shower like the sauna room.

　　1. First, place the bottom of the sweat steaming room flat on the ground, with one groove on each side of the bottom and two grooves at the back.

　　2. Place the back of the sweat steaming room on top of the bottom, and make sure that the two wooden strips are embedded in the grooves. At this point, one person is needed to support the back of the sweat steaming room and prevent it from collapsing.

　　3. Place one side of the sweat steaming room above the bottom, and also insert the wooden strip into the groove. At this point, the copper buttons at the bottom, back, and side can be fastened, and the sweat steaming room can basically stand on its own without the need for support.

　　4. At this point, the seat plate in the sweat steaming room needs to be installed inside the sweat steaming room.

　　5. Repeat the same step and install the door on the other side above the bottom, while also fastening the copper buckle.

　　6. Place the door of the sweat steaming room above the bottom and fasten the copper buckle. This step should be noted that the doors of the sweat steaming room are mostly glass doors. During installation, it is important to close the doors tightly to avoid damaging the glass on the doors.

　　7. Finally, cover the top cover of the sweat steaming room on the group

Read recommendations:

cold plunge tub with chiller for sale

infrared sauna 2 person indoor

outdoor sauna cube

cold plunge tub chiller design

outdoor wooden hot tub.What are the benefits of a sweat steaming room?